Designing and manufacturing high-quality multi-gigabit test fixtures and reference designs for broad-band digital communication protocols since 2012
PRODUCTS
USB 3.2 Type-C to SMA Breakout Board
The SS-USB3.2C-SMA breakout board is designed to test everything USB, from USB-2.0 up through dual-lane USB-3.2. It incorporates a standards compliant USB Type-C connector (plug or receptacle boards are available) on one end of the printed circuit board and 20 GHz SMA connectors on the other end of the board. High-speed transmit and receive signals are routed to the SMA connectors via 50-ohm microstrip transmission lines over Rogers R04350 low-loss dielectric for excellent signal integrity at frequencies up to 30 GHz.
USB 3.2 Type-C to SMA Datasheet
Price: $875.00
Weight: 0.5lb.
Dimensions: 3.8in. x 5.5in x 0.75in
SFP+ to SMA Breakout Board
The SS-SFP-SMA breakout board is an SFP+ Host Compliance Test Board (HCTB). It incorporates a standards compliant 20-pin SFP+ “gold finger” board-edge connector on one end of a printed circuit (PC) board and high-speed SMA connectors on the other end of the PC board. High-speed transmit and receive signals are routed to the SMA connectors via 50-ohm microstrip transmission lines over Rogers RO4350 low-loss dielectric for excellent signal integrity at data rates up to 11Gbps or more. Low-speed signals Tx_Fault, SDA, SCL, Mod_ABS, and Rx_LOS are routed to standard 0.1 inch header pins. Tx_Disable, RSO, RS1, VccT, and VccF are routed to test points and include LED indicators. The breakout boards enable test, debug, and development of SFP+ links.
Serial ATA (SATA) to SMA Breakout Board
– Standard configuration includes 4 SMA connectors (TX and RX pairs)
– Optional add-on 4 monitor SMA connectors (for 8 SMA connectors total)
The SS-SATA-SMA breakout board incorporate a standard SATA male connector on one end of a printed circuit (PC) board and high-speed SMA connectors on the other end of the PC board. High-speed 50-ohm controlled impedance microstrip transmission lines of matched length connect the SATA pins to the SMAs. The breakout boards enable test, debug, and development of SATA links. The optional monitor connections split off a small portion of the signal, allowing monitoring of the signals on an active SATA link.
SATA to SMA Datasheet
Price $295.00 (Standard Config)
Weight: 0.25 lb.
Dimensions: 2.5in. x 2.5in
USB-3.0 to SMA Breakout Board
(Discontinued - Information for Legacy Support Only)
USB-3.0 to SMA Breakout Board, Plug or Receptacle,
– Standard configuration includes 4 SMA connectors (TX and RX pairs)
– Optional add-on 4 monitor SMA connectors (for 8 SMA connectors total)
The SS-USB3-SMA breakout boards incorporate a standard USB-3.0 type-A connector on one end of a printed circuit (PC) board and high-speed SMA connectors on the other end of the PC board. Super Speed 5Gbps pins are routed to the SMA connectors via 50-ohm microstrip transmission lines USB-2.0 signals (VBUS, D-, D+, and GND) are routed to standard 0.1 inch header pins. The breakout boards enable test, debug, and development of USB-3.0 links.
USB-3.0 to SMA Datasheet
Price: Discontinued
Weight: 0.25 lb.
Dimensions: 3.5in. x 2.5in.